RennDME Documentation

USB-C enabled DME's can monitor live data through a serial monitor at a 500000 baudrate. If you do not have a preferred IDE the following guide will walk you through the process of installing the Arduino IDE, pulling the RennDME package into the IDE, and opening a Serial Monitor.

1. Download and install the Arduino IDE --> LINK

2. Open the IDE and select from the top drop down boxes File -> Preferences

3. Copy and past the following address into the box: "Additional boards manager URLs:"
   https://raw.githubusercontent.com/two-7/RennDME/main/package_renn27_index.json

4. Select from the top drop down boxes Tools -> Board -> Boards Manager...

5. Search Renn27 SAMD Boards and install the board package.

6. Plug in your USB-C enabled RennDME

7. Select from the top drop down boxes Tools -> Port -> then select the active COMPORT the RennDME is active on

8. Select from the top drop down boxes Tools -> Board -> Renn27 SAMD Boards -> RennDME

9. Select from the top drop down boxes Tools -> Serial Monitor

10. The serial monitor box opens in the lower part of the screen, select new line and 500000 baud respectively in the dropdown boxes

11. The monitor will now display the RennDME's available data at 1Hz.